☽
Trending News

Is water killing your laser mirror coating?

Er:YAG lasers achieve high precision in dental and dermatological procedures because their 2940-nanometre output is absorbed so strongly by water that it penetrates tissue only to a depth of about one thousandth of a millimetre. This same property creates a durability challenge for the mirrors and lenses that direct the beam: any water molecules trapped inside the thin-film coatings absorb laser energy and cause the coatings to degrade more rapidly. When that occurs, less energy reaches the treatment handpiece, a technician must replace the optic, and the treatment room stands idle. The problem grows more relevant as Er:YAG systems proliferate in clinics.

Each laser pulse converts the water within that thin tissue layer into steam, removing material before heat diffuses to surrounding structures. Mid-infrared light travels poorly through ordinary glass fibres, so delivery occurs through an articulated arm that incorporates a mirror at every joint. The reflective coatings consist of many very thin layers whose performance at 2940 nm declines when O-H bonds from residual water or hydroxyl groups remain inside them. Transmissive optics avoid this difficulty by using sapphire or calcium fluoride substrates that exhibit markedly lower absorption at the operating wavelength than glass does.

Demand for these lasers continues to increase. IndexBox projects 5.8 percent annual growth through 2035. Manufacturers are responding with production investments, including BIOLASE’s nearly one-million-dollar expansion of its California facility to safeguard quality and supply. Altechna, an optics manufacturer with sites in Lithuania and the United States, addresses the coating issue in a newly released whitepaper that details process choices capable of limiting water incorporation at 2940 nm.

“Every mirror that fails in the field means a service visit for the laser maker and lost treatment time for the clinic,” said Antanas Laurutis, CEO of Altechna. “That is why we deal with the cause in the coating chamber. The less water there is in the coating, the less of the beam it absorbs, and the longer the mirror lasts.”

“Most coating systems monitor layers only up to about 1100 nanometres, so during deposition you can’t check the coating at the wavelength it will actually be used at,” said Laurynas Lukoševičius, PhD, Chief Scientist at Altechna. "You have to know the materials well enough to get it right without seeing it, because spectral deviations only show up later, at post-production inspection."

Altechna reduces both sources of contamination through three coordinated controls. A load-lock chamber accepts substrates from room air and pumps them down before an internal door opens to the main coating volume, which therefore stays sealed between batches and reaches a base pressure ten to one hundred times lower than that of vented systems. Ion-plasma treatment then removes remaining surface moisture from each part and assists densification of the first layers. Magnetron sputtering produces dense, non-porous films whose surface roughness remains below 3 ångströms after deposition of coatings 3–10 micrometres thick, comfortably inside the typical customer limit of 10 ångströms.

Measurements on the resulting turning mirrors show laser-induced damage thresholds above 8,000 J/cm² for 300-microsecond pulses at 2 Hz together with reflectance exceeding 99.9 percent at 2940 nm. Because damage thresholds depend on pulse duration, wavelength and repetition rate, the published figures apply only under conditions close to actual use. Clinics selecting Er:YAG systems can therefore ask manufacturers how the articulated-arm optics were tested, under what exact parameters, and what service intervals are typical in clinical service. Full specifications appear in the Altechna whitepaper.

Share via: