☽
Trending News

Does trapped water wreck your laser mirror coating?

Trapped water in optical coatings can shorten mirror lifespan in Er:YAG lasers because the 2940-nanometre wavelength that water absorbs strongly in tissue also heats and degrades any moisture present in the thin-film layers. Dentists and dermatologists rely on these lasers for precise cutting of teeth, gums and skin, yet any absorbed beam energy reduces delivered power at the handpiece, forces technician replacements and leaves treatment rooms idle. The effect arises directly from the same O–H bond interaction that enables clean tissue ablation without collateral thermal damage.

Er:YAG light penetrates tissue only about one-thousandth of a millimetre before water turns to steam and removes material. Because ordinary glass fibres cannot transmit this infrared wavelength and mid-infrared fibres remain costly and fragile, the beam travels through articulated arms fitted with a mirror at every joint. Each mirror must reflect the full pulse energy on every shot, so any O–H bonds trapped in the multilayer coating or introduced later through porosity absorb energy and accelerate failure.

Altechna’s whitepaper outlines coating-chamber practices designed to keep water out of the finished layers. “Every mirror that fails in the field means a service visit for the laser maker and lost treatment time for the clinic,” said Antanas Laurutis, CEO of Altechna. “That is why we deal with the cause in the coating chamber. The less water there is in the coating, the less of the beam it absorbs, and the longer the mirror lasts.”

Demand for Er:YAG lasers is forecast to grow 5.8 percent annually through 2035, according to IndexBox, prompting manufacturers to focus on component reliability. In June, BIOLASE announced an investment of nearly one million dollars at its California facility to safeguard laser quality and supply.

Deposition monitoring adds further difficulty: most systems track layers only to about 1100 nanometres, so operators cannot verify performance at the actual 2940-nanometre operating wavelength during growth. “Most coating systems monitor layers only up to about 1100 nanometres, so during deposition you can’t check the coating at the wavelength it will actually be used at,” said Laurynas Lukoševičius, PhD, Chief Scientist at Altechna. “You have to know the materials well enough to get it right without seeing it, because spectral deviations only show up later, at post-production inspection.” Residual chamber moisture can also incorporate into the films if not removed before deposition begins.

Altechna reduces both sources of moisture with a load-lock transfer chamber that keeps the main coating volume isolated from room air, routinely achieving base pressures ten to one hundred times lower than conventional open systems. Ion-plasma treatment cleans residual water from part surfaces before coating and assists densification of the initial layers. Magnetron sputtering then produces non-porous films whose surface roughness stays below 3 ångströms even after thicknesses of 3–10 micrometres, limiting post-process uptake of atmospheric moisture.

Measured laser-induced damage thresholds for the resulting turning mirrors exceed 8,000 J/cm² under 300-microsecond pulses at 2 Hz while maintaining reflectance above 99.9 percent at 2940 nm. Because thresholds vary with pulse duration, wavelength and repetition rate, clinics evaluating Er:YAG systems are advised to ask manufacturers for test conditions matched to their laser parameters and for typical articulated-arm service intervals. Full specifications appear in the whitepaper.

Share via: